Please clean any remaining pieces of gasket off the old reedvalve before installing the new kit
reedvalve, gasket, black plastic sealing, gasket, alu sealing with M5x30mm sink head screws, small gasket, carburetor, intake adapter with M5x50mm screws
Please check the throttle cable position, slack and operation because with the new intake kit the carb sits at a slightly different angle.
Please observe proper leaning procedures as follows:
Let engine warm up completely, then lean by turning the thumb screw very slowly clockwise until you get max rpm. Now turn the screw counterclockwise until rpms drop by 50.
That’s it. You can repeat if a large change in temp occurs.
During break in avoid prolonged periods of full throttle.
Sorry for the inconvenience!
Chris
